Tacoma Service Manual 2018
/ / / Disassembly DISASSEMBLY PROCEDURE 1. REMOVE KNUCKLE GREASE RETAINER CAP (for 2WD) (a) Using a screwdriver and hammer, remove the knuckle grease retainer cap. REMOVE FRONT AXLE HUB OIL SEAL (for 4WD) (a) Using a screwdriver and hammer, remove the front axle hub oil seal. REMOVE FRONT WHEEL ADJUSTING NUT (for 2WD) (a) Using SST and a hammer, unstake the front wheel adjusting nut. SST: 0 (b) Using SST, remove the front wheel adjusting nut. REMOVE FRONT AXLE HUB (a) Remove the 4 bolts and axle hub from the steering knuckle. (b) Remove the O-ring from the axle hub.
REMOVE FRONT AXLE WITH ABS ROTOR BEARING ASSEMBLY (a) Gently fix the front axle hub in a vise. (b) Using SST, remove the bearing.
SST: 1 1 SST: 1 0 0 0 0 1 0 1 6. REMOVE FRONT AXLE HUB OIL SEAL (a) Using a screwdriver, remove the front axle hub oil seal. Other materials: REASSEMBLY PROCEDURE 1. INSTALL UN-LOCK WARNING SWITCH ASSEMBLY (w/o Smart Key System) (a) Engage the 2 claws to install the un-lock warning switch assembly to the upper steering column bracket assembly. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Smart Key System) (a) T.
FREEZE FRAME DATA 1. FREEZE FRAME DATA HINT: Whenever a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) state as freeze frame data. The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned f. Carry out the following procedures if the tires spin or the vehicle becomes stuck in mud, dirt, or snow. Stop the engine.
Tacoma Owners Manual 2018
2018 Tacoma Service Manual
Set the parking brake and put the shift lever in P (vehicles with an automatic transmission) or N (vehicles with a manual transmission). Remove the mud, snow, or sand f.