Hello all, So my boss told me to open up Mastercam Wire version 9.1 and mess around with it and see if I could figure out how to use/program with it. Well after a while of messing around with different stuff I saved my program and tried to open my program up in CIMCO Edit. As far as I could tell my program looked fine but all of my G-codes were different.

I assume that I just need a different post or something for Mastercam so I figured I would see if anyone on here could help me. Justin Similar Threads:.

Need Help!-. Need Help!

Renault Cars MEGANE 2006 Owner Manual: Bookmarks and Contents, for online reading and free download. Renault megane 06 manual. Haynes Publishing provide manuals for a wide range of Renault models. Learn how to make. Megane Scenic (2003 - 2006) Megane Scenic (1999 - 2002). View and Download Renault Megane driver's handbook manual online. Megane Automobile pdf manual download.

Robofil 440 manual

KirlB, Thanks for the response. We did check the spring tension on the pinch rollers and the tension was off. Even with that corrected, we still had a problem.

Robofil 440 Manual

Manual

As a side question, the spring length for the wire that we were using is 22mm. The picture in the manual is confusing. Is the measurement from the outside of the bracket to the outside of the spring cover washer?

The problem turned out to be the plastic cover on the lower head. The pulleys etc. Under the head were rubbing against the plastic.

The wear marks were machined off, & the problem disappeared. This is a used machine, new to us. The suspicion is that cover was over tightened to guarantee a good seal.

Joe Last edited by jcoehlo; at 08:05 AM. Reason: typo.